I now have finished final "assembly" and installation of the tBeacon. You can't see it, but in order to route the tBeacon's antenna as vertically as possible (for maximum signal), I put inside a straw and routed it down the start of the wire channels in the tail boom. The antenna is probably about 30 degrees off from vertical now.
I soldered the wire harness that I planned out by the
previous post.
I had to solder the tBeacon's included 50mAh lipo battery to the circuit board terminals. I then put shrink wrap over the assembly.
 |
| Custom Harness |
 |
| tBeacon with Battery Soldered |
 |
| Completed with the Shrink Wrap |
 |
| Installed. In this picture, the tBeacon's antenna runs down and to the right. |
No comments:
Post a Comment