Saturday, March 17, 2018

Vortex 230 Mojo, Dragon Link

I received and installed the Dragon Link Nano receiver in my quad. This enables basically unlimited range, which is unnecessary on a small race style quad, but it ensures that I won't ever get drop outs when I'm flying around obstacles, or if I do feel like pushing it out a mile or so.

I got some flights in after the installation. It is very difficult to fly in a tight area like in these videos. I need a lot of practice to gain some confidence for getting closer to obstacles. I also noticed that the video performance was quite bad. A higher gain receiver antenna will definitely help in the future.









Here's how I mounted the Dragon Link receiver antennas.

Here's the receiver installed inside.

Thursday, March 8, 2018

System Level Schematic

I thought it would be interesting to look at a "map" of all the communications that are set up and operating with my current FPV setup on the Sabre.

Note that this does not include the tBeacon or HAM radio. These are only ever going to be used to find the plane in the event that it goes down, and wouldn't add much value to this diagram.

Note: It makes the most sense to start with the orange 2.4 GHz transmitter, and then work your way around.


Tuesday, March 6, 2018

Sabre: New Photos Inside the Fuselage

Since the installation of the tBeacon and camera switcher, I decided to take some photos to show the electronics section of the Sabre.

These photos are taken through the opening in the top of the fuselage directly below where the wing attaches, behind where the flight battery sits.


Electronics with Labels

Electronics







Sabre: Camera Switcher Update, Belly Camera

I realized that it would be very easy and straightforward to add a third camera to the Sabre. The camera switcher is 3 position, I have a 3rd FPV camera, and the Sabre already has a spot to put a camera in the belly. I used my Runcam PZ0420H CCD camera in the recess in the belly of the Sabre.

To do this, all I had to do was make a small hole to route the wires up to the electronics section, to plug into the camera switcher.


I used Velcro to secure the camera.

Paper towels were used to snug the fit to help prevent vibration or dislodging.

I made a simple cardboard cover. Packaging tape holds it in place.



Monday, March 5, 2018

Updated Ground Station Schematic

I updated the ground station schematic to the most recent actual configuration.

I also added dashed lines to indicate where there are options.

Equipment as it is Presently Configured. Dashed lines indicate optional connections.

Sabre Airborne Equipment Schematic, Updated

This version reflects the following changes:

  1. Change BEC power input from main battery balance lead to Micro Deans, tapped off of main discharge lead.
  2. Addition of camera #3.
  3. Rewire camera switcher to receive power from Vector.

Friday, March 2, 2018

1.2/1.3 GHz Ground Station Complete

Updated 3/7/18: Added V2 picture with labels.

I now have installed the latest round of equipment on my ground station, and set it up for diversity. With the latest changes, I now consider my ground station done and ready for use for flying in the spring. I can still add the Lumnier monitor somewhere on the tripod, but it is just as easy to use as a standalone unit.

All of the gear is mounted to back the Crosshair antenna with Velcro. It took several iterations to get everything to just fit without interfering with the tripod.


V1: Component Labels










 
V2: Some Subtle rearranging and neatening of the layout.